Externally Variable Controller
(Yellow)
Function:
User can vary the console’s fan speed anywhere
between demand and full speed.
Can be used to set higher-than-standard minimum
speed.
Detail:
Same function as the red/white but these modules can be fitted
to your console and allow the speed of the fan to be varied from
outside the case. They will not, however, allow the speed to be
reduced below that which the system demands. In other words,
there will never be too little cooling.
The control potentiometer (pot) is designed to be fitted through
the console case and secured with the nut (provided) which will
require at least one hole to be drilled, although there is no
reason why the cable shouldn't be passed through a small slot
and the pot attached to the outside of the case using glue or
double-sided tape... or even just left hanging!
A drilling template will be included with the module.
This version of controller is only available for certain consoles as
the more recent boxes have too little space inside to fit the
required control pot. However, if you are happy to find your own
means of mounting the pot in one of the consoles with limited
space, I’d be more than willing to create a one-off controller for
your needs.
PS3
All variants
PS4
2nd Generation & Pro:
CUH-12xxx
CUH-70xxx
CUH-71xxx
Xbox
All versions
except original
Xbox 360
PS3
All variants
PS4
2nd Generation & Pro:
CUH-12xxx
CUH-70xxx
CUH-71xxx
Xbox
All versions
except original
Xbox 360