Your basket is empty.

Added to Basket
47f0a992d2c79e9a659d50e84118cd80

Xbox External Fan Speed Controller

£17.49

(Quantity discounts available)

Specification
Product CodeXBX-EXT-YEL
ConditionNew

This module is suitable for all Xbox consoles other than the original Xbox 360.
It is suitable for the following consoles:
Xbox 360 Slim
Xbox One
Xbox One S
Xbox One X (Scorpio)

This mod will allow the speed of the fan to be varied continuously from outside the case.

It will not, however, allow the speed to be reduced below that which the system demands. In other words, there will never be too little cooling.

Whilst the speed is varied by adjusting a potentiometer (pot), the module controls the fan using the correct Pulse Width Modulation (PWM) techniques and so causes no extra strain on the fan or its associated electronics.

The module is built on a high quality professionally made pcb and uses very reliable surface mount technology. The module itself is easy to fit: no soldering required, just unplug the fan, plug this module in its place and then plug the fan into the module.

The control pot is designed to be fitted through case and secured with the nut (provided) which will require at least one hole to be drilled, although there is no reason why the cable shouldn't be passed through a small slot and the pot attached to the outside of the case using glue or double-sided tape... or even just left hanging!  There is approximately 300mm of cable to the pot, which is sufficient to reach anywhere along the sides of the console.

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.


QuantityPrice per unit
5+£15.32
10+£14.59
50+£13.87
100+£13.14

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

1 2 3 4 5
 

Verify you are a human

 
Please enter a valid email address.
This field is required.