Your basket is empty.

Added to Basket

Xbox Variable Fan Speed Controller (Red)


(Quantity discounts available)

Product Code980602

This module is suitable for all Xbox consoles other than the original Xbox 360.
It is suitable for the following consoles:
Xbox 360 Slim
Xbox One
Xbox One S
Xbox One X (Scorpio)

This is a small module that can be fitted to your console that will allow you to increase the base (minimum) speed of the fan. This base speed is continuously variable all the way up to full speed by means of the small control on the pcb, using a small flat-bladed (2mm) screwdriver.

If the console gets too warm for the selected speed, then the fan will run at the speed required by the system so, for example, if you've set the speed to about half way and the console requires more cooling, the system-set speed will take over to drive the fan at the increased speed. As the console cools down again, the speed will fall back until it reaches that set by the module, therefore the system will never have too little cooling.

Note that this module drives the fan with the correct PWM (Pulse Width Modulation) signal and so causes no extra strain on the fan. Simply fitting a potentiometer is not the correct way to control the speed and may cause premature failure of the fan!

The module is built on a high quality professionally made pcb and uses very reliable surface mount technology. It is easy to fit: no soldering required, just unplug the fan, plug this module in its place and then plug the fan into the module. Fitting details are available as a downloadable PDF document.

You will need to open the case in order to fit the module, so please be aware that this will invalidate your warranty.


You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.

QuantityPrice per unit

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

1 2 3 4 5

Verify you are a human

Please enter a valid email address.
This field is required.