Your basket is empty.

Added to Basket

PS3 Illuminated Fan Speed Controller


(Quantity discounts available)

Product Code980306

This is a small module that can be fitted to your Playstation 3 that will allows the speed of the fan to be varied continuously from outside the case by means of a small (2mm) screwdriver. A suitable screwdriver can be found here.

With this module, only a small (3mm) hole needs to be drilled in the case at a suitable position. The photo's above show the unit fitted into a PS3 Slim. 

The control pot is mounted inside the case by means of the self-adhesive feet (supplied). An LED mounted behind the pot illuminates the hole drilled in the case to make location easy, regardless of light levels in your room.

This will work with all versions of the Playstation 3.

Whilst the speed is varied by adjusting a potentiometer (pot), the module controls the fan using the correct Pulse Width Modulation (PWM) techniques and so causes no extra strain on the fan or its associated electronics.

The module is built on a high quality professionally made pcb and uses very reliable surface mount technology. The module itself is easy to fit: no soldering required, just unplug the fan, plug this module in its place and then plug the fan into the module.

The unit comes with approximately 300mm of cable to the pot, but if you need a longer length, up to 600mm, I can provide that if you email me with your requirement.

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.

QuantityPrice per unit

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

1 2 3 4 5

Verify you are a human

Please enter a valid email address.
This field is required.