This is a Power over Ethernet adaptor for the Raspberry Pi B+ and the Raspberry Pi 2. It is compatible with systems conforming to IEEE802.3at and is also backward compatible with IEEE802.3af
The module features the PoE itself, a battery backed real time clock/calendar/alarm and the facility to accept an additional power source (such as a battery) as a back-up in case the Ethernet gets disconnected.
In addition to powering the Pi, the board is able to provide 5 volts at over 1 amp to external circuitry via the power output solder pads. It is capable of supplying over 2.5 amps if additional cooling (such as a fan) is provided and the Ethernet source also has the power capability.
The GPIO pins extend above the board, so full access to these is maintained.
Click here for a PDF document with full details
Main Features:
Compatible with IEEE 802.3af and IEEE 802.3at Power over Ethernet standards
Capable of supplying up to 2.5 amps* to additional circuitry
Screw terminal point for secondary (back-up) power supply
Solder pads for power supply connection to external circuitry
Pads are suitable for standard PCB mount terminal block (Not supplied)
Real Time Clock & Calendar with alarm output
RTCC is itself independently battery backed by means of a small coin cell
Fits directly onto GPIO port
Duplicate port on adaptor allows full access to the Pi’s GPIO port
Mechanical support for board by supplied spacers and screws
Network connection to the Pi by short link cable supplied
* Currents higher than 1 amp will require additional cooling (such as a fan) and will also depend on the capacity of the PoE switch/injector.
You will receive the items in the picture below, i.e.:-

The Raspberry Pi and other items are shown solely for illustration purposes and are NOT included.
Customer Reviews
Please enter a valid email address.
This field is required.